Project Notchback
Bill's 1989 mustang notchback cam in as a bone stock mustang with a set of rims and
exhaust. This project was completed in three weeks.
exhaust. This project was completed in three weeks.
Bill's short block is together and we are waiting on some parts to complete the long block.
We assembled the long block with a set of afr's and a custom ground camshaft.
With the engine bay stripped and cleaned it was time to assemble the car.
Final pictures of Bill's notch back when he picked it up.
Mouthracing's Project Notch Back
Build Information
Owner. Bill
Engine. Built by Mouth Racing 306 small block ford
Nitrous. N.O.S. Installed and tuned by Mouthracing.com
Transmission. Tremec T600
Clutch. Spec
Front suspension. Eibach drag springs, koni 90-10 struts
Rear suspension. Koni shocks,south side lower arms,Granitelli upper arms.
Rear End. 8.8 rear axle moser 31 spline axles,eaton carrier 1/2 studs, carrier support cover.
Exhaust. bbk headers, mufflers,tailpipes,custom x pipe installed by American Muffler.
Body and Paint. Colonial auto body
Fuel system and wiring. All done at Mouth Racing.
Build Information
Owner. Bill
Engine. Built by Mouth Racing 306 small block ford
Nitrous. N.O.S. Installed and tuned by Mouthracing.com
Transmission. Tremec T600
Clutch. Spec
Front suspension. Eibach drag springs, koni 90-10 struts
Rear suspension. Koni shocks,south side lower arms,Granitelli upper arms.
Rear End. 8.8 rear axle moser 31 spline axles,eaton carrier 1/2 studs, carrier support cover.
Exhaust. bbk headers, mufflers,tailpipes,custom x pipe installed by American Muffler.
Body and Paint. Colonial auto body
Fuel system and wiring. All done at Mouth Racing.