Project Mouthracing's
drag radial Camaro
drag radial Camaro
25-2 / 25-5 stock suspension drag radial camaro
This is the new Mouthracing's drag radial Camaro we will start
our work in November 2006 and hope to be done May of 2007.
our work in November 2006 and hope to be done May of 2007.
Aje front clip with there manual rack set up. moser 9 inch housing
with 40 spline axles wolfcraft lower arms and pan hard bar
with 40 spline axles wolfcraft lower arms and pan hard bar
The rear suspension is complete with anti roll bar,coil over shock mounts,and the wishbone arm
The 25-2 floor bars are just about complete with the camaro's unique floor Nick
Montana ran some bars through the floor for maximum ground clearance
Montana ran some bars through the floor for maximum ground clearance
Mounted the 295 drag radials on the car and they are tucked up real nice...
The cage is just about complete with just final welding to be done
They installed the bars to the front with aluminium motor plate and mid plate
After thanksgiving were finally getting started on the metal work rear quarters being
stretched,battery mounts,new race steering column,pro brake pedal assembly,and headers.
stretched,battery mounts,new race steering column,pro brake pedal assembly,and headers.
We mounted the steering column,brake and gas assembly most of
the sheet metal fabing is done and we're test fitting the dash.
the sheet metal fabing is done and we're test fitting the dash.
We just laid the engine in to take pictures.